AFS3-01000200-10-ULN

Overview

The AFS3-01000200-10-ULN is an active RF amplifier module manufactured by L3 Narda-MITEQ, designed for the 1 GHz to 2 GHz frequency range. It provides a nominal gain of 34 dB with a noise figure of 1 dB and a P1dB output power of 10 dBm. The device operates on a single 15V supply voltage, drawing a current of 150 mA. Packaged in a standardized module form factor within the AFS series, it serves as a high-performance component for signal conditioning in radio frequency applications.

Feature Summary

• Provides high linearity performance with a 10 dBm P1dB output level suitable for sensitive signal chains
• Delivers low noise characteristics with a 1 dB noise figure for improved signal-to-noise ratio
• Offers substantial amplification with a 34 dB gain specification across the designated frequency band

Applications

• GPS receiver front-end amplification
• General purpose RF signal conditioning
• Communication system intermediate stage amplification

Procurement Notes

Verify that the specific suffix -ULN corresponds to the required regulatory compliance or pinout configuration for your assembly. Confirm the module package dimensions match your PCB layout constraints. Ensure the 15V DC supply capability aligns with your system power architecture before finalizing procurement orders.

Selection Notes

Select this component when a balance of moderate output power (10 dBm) and ultra-low noise (1 dB) is required in the 1-2 GHz band. Consider the 15V operating voltage requirement against available system rails. Evaluate the 150 mA current draw against thermal management capabilities within the target enclosure design.

Part Context

This part belongs to the AFS series of RF amplifiers from L3 Narda-MITEQ. The series utilizes a modular construction approach, allowing for consistent performance across various frequency bands defined by the numeric codes in the part number. This specific model targets the lower microwave spectrum.

Replacement Considerations

Consult official L3 Narda-MITEQ documentation for direct cross-reference equivalents. Verify electrical parameters such as gain flatness and noise figure if substituting with other manufacturers' modules to ensure system compatibility.