AFS3-07250775-06-10P-4-R

RF Amplifiers Overview

The L3 Narda-MITEQ AFS3-07250775-06-10P-4-R is an active RF amplifier IC designed for general-purpose applications within the 7.25 GHz to 7.75 GHz frequency range. It operates with a supply current of 80 mA and delivers a gain of 30 dB. The component features a P1dB output power of 10 dBm and a noise figure of 0.6 dB, packaged in a module form factor.

RF Amplifiers Feature Summary

• Integrated RF amplifier module optimized for high-frequency signal amplification
• Low noise figure performance suitable for sensitive receiver front-ends
• General-purpose design compatible with standard RF system architectures

RF Amplifiers Applications

• GPS signal processing systems
• Satellite communication uplinks and downlinks
• Test and measurement instrumentation

RF Amplifiers Procurement Notes

Verify the exact suffix against manufacturer documentation to confirm pinout and electrical tolerances. Ensure compatibility with existing biasing networks given the 80 mA supply requirement. Cross-reference the datasheet revision to validate the 0.6 dB noise figure specification for your specific batch or lot code.

RF Amplifiers Selection Notes

Select this component when a low-noise, moderate-power amplifier is required at 7.25–7.75 GHz. Compare the 0.6 dB noise figure against alternatives if system sensitivity is critical. Confirm that the 10 dBm P1dB meets linearity requirements without excessive intermodulation distortion in your specific circuit topology.

RF Amplifiers Part Context

This part belongs to the AFS3 series from L3 Narda-MITEQ, which focuses on GaAs-based MMIC amplifiers. The series typically offers compact modules for microwave frequencies. This specific model targets C-band or Ku-band satellite applications requiring stable gain and minimal noise addition.

RF Amplifiers Replacement Considerations

Check for direct substitutes like the AFS3-07250775-07-10P-4-BTO, noting its higher typical noise figure of 2.1 dB. Verify if the increased noise tolerance is acceptable for your application before swapping.