CSC16/7.9/14-4S2-EN

Overview

The CSC16/7.9/14-4S2-EN is a hinged snap-on cable ferrite core manufactured by Ferroxcube. It utilizes 4S2 soft ferrite material, characterized by high permeability suitable for electromagnetic interference suppression in low-frequency applications. The component features an openable design with a single aperture, allowing installation on cables without disconnection. Physical dimensions are defined by the model designation: 16mm length, 7.9mm width, and 14mm height. The internal diameter accommodates cables up to 7.60mm (0.299 inches). At 100MHz, it provides an impedance of 113 Ohms.

Feature Summary

• Hinged snap-on chassis mount design enables rapid installation on existing cables
• Single aperture configuration supports round cable shielding requirements
• Constructed from 4S2 ferrite material optimized for EMI suppression

Applications

• Electromagnetic interference suppression on power and signal cables
• Cable shielding in consumer electronics assemblies
• EMI mitigation in industrial control wiring

Procurement Notes

Verify the specific suffix 'EN' against official Ferroxcube documentation to confirm environmental compliance or regional specification variations. Ensure the required cable diameter does not exceed the 7.60mm internal aperture limit. Confirm that the 4S2 material grade aligns with the target frequency range for effective impedance performance.

Selection Notes

Select this component when a non-intrusive, snap-on ferrite solution is required for cables with diameters up to 7.60mm. The 4S2 material offers high initial permeability, making it appropriate for suppressing lower frequency noise compared to higher-frequency materials. Consider the physical envelope of 16x7.9x14mm for spatial constraints within the equipment enclosure.

Part Context

This part belongs to the Ferroxcube CSC series of cable ferrites. The CSC series provides openable cores for easy retrofitting. The 4S2 material is a manganese-zinc ferrite known for high permeability, typically used in applications requiring effective noise suppression at frequencies below several megahertz.

Replacement Considerations

Direct substitutes must match the 16x7.9x14mm dimensions, 7.60mm ID, and 4S2 material composition. Verify impedance characteristics at the operating frequency if substituting with different material grades.