LNA-40-08001200-09-10P

Overview

The LNA-40-08001200-09-10P is a low noise amplifier manufactured by L3 Narda-MITEQ, designed for VSAT applications. It operates within a frequency range of 8 GHz to 12 GHz. The device provides a gain of 40 dB with a P1dB output power of 10 dBm. Its noise figure is specified at 0.9 dB. The unit requires a supply voltage of 15 V and draws a current of 10 mA. It is housed in a module package equipped with SMA connectors.

Feature Summary

• Optimized for Very Small Aperture Terminal (VSAT) satellite communication systems
• High gain performance with low noise figure for signal integrity
• Integrated module design with SMA connectors for straightforward integration

Applications

• VSAT uplink and downlink receiver chains
• Satellite communication ground stations
• Microwave radio relay systems

Procurement Notes

Verify the specific suffix codes against the manufacturer's official datasheet to ensure correct pinout and connector configuration. Confirm RoHS compliance status and REACH regulations applicability for your region before finalizing procurement orders. Cross-reference the part number with authorized distributors to avoid counterfeit components.

Selection Notes

Select this component when a high-gain, low-noise solution is required for the 8-12 GHz band. Ensure the system can accommodate the 15V supply requirement and 10mA current draw. Compare the 0.9 dB noise figure against system link budget requirements to verify adequate sensitivity margins for the intended satellite application.

Part Context

This model belongs to the LNA series from L3 Narda-MITEQ, which specializes in RF amplifiers for wireless infrastructure. The naming convention typically indicates gain, frequency range, and other key parameters. Similar models in the series may offer different gain levels or frequency ranges while maintaining the same module form factor.

Replacement Considerations

Direct replacements must match the 8-12 GHz frequency range, 40 dB gain, and 15V supply voltage. Verify that any substitute component maintains the SMA connector interface and comparable noise figure specifications to ensure system compatibility without redesign.