MF72-060D9

Inrush Current Limiters (ICL) Overview

The Cantherm MF72-060D9 is an inrush current limiter (ICL) from the MF72 series, designed for circuit protection. It features a nominal resistance of 60 Ohms with a tolerance of ±20%. The component supports a maximum steady-state current of 800 mA and has a diameter of 0.433 inches (11.00 mm).

Inrush Current Limiters (ICL) Feature Summary

• Provides effective inrush current limiting to protect sensitive electronic components during power-up.
• Utilizes thermistor technology that automatically adjusts resistance based on temperature changes.
• Designed for through-hole mounting with lead spacing compatible with standard PCB layouts.

Inrush Current Limiters (ICL) Applications

• Power supply input stages
• Transformer primary circuits
• Capacitor charging protection

Inrush Current Limiters (ICL) Procurement Notes

Verify the specific resistance value and current rating against the application requirements before ordering. Confirm the physical dimensions match the available board space. Check for RoHS compliance status if required by the manufacturing process. Ensure the supplier provides official datasheets for final validation.

Inrush Current Limiters (ICL) Selection Notes

Select this component when a higher initial resistance is needed compared to lower-ohm variants in the same series. Consider the thermal dissipation capabilities relative to the duty cycle. Evaluate the steady-state current limit to ensure it exceeds the operating current without overheating.

Inrush Current Limiters (ICL) Part Context

This part belongs to the MF72 series of inrush current limiters manufactured by Cantherm. The series offers various resistance values and physical sizes to suit different power levels. These components are commonly used in consumer electronics and industrial equipment for surge protection.

Inrush Current Limiters (ICL) Replacement Considerations

Public confirmed substitute part numbers include BN-LG13Y6R0MYB from Bourns Inc. Verify electrical parameters and mechanical fit before substitution.