SLP-5+

Overview

The SLP-5+ is a lumped LC low-pass filter manufactured by Mini-Circuits, designed for signal conditioning in RF systems. It operates over a frequency range from DC to 5 MHz with a specified cutoff at 6 MHz. The component features a 50 Ohm impedance and utilizes SMA connectors for in-line module integration. This coaxial filter provides attenuation of higher frequencies while maintaining signal integrity within the passband.

Feature Summary

• Lumped LC architecture for effective low-pass filtering
• SMA connector interface for standard RF integration
• Coaxial in-line module design

Applications

• RF signal conditioning
• Low-pass filtering in communication systems
• Test and measurement equipment

Procurement Notes

Verify the specific datasheet version when ordering, as electrical specifications are based on Mini-Circuits' applicable documentation. Confirm that the SMA connector type matches your system requirements. Ensure the 50 Ohm impedance aligns with your circuit design. Check environmental specifications if operating in demanding conditions. Always refer to the official manufacturer data sheet for final validation before implementation.

Selection Notes

Select this component when a low-pass filter with a cutoff near 6 MHz is required for 50 Ohm systems. The lumped LC design offers a compact solution for frequencies up to 5 MHz. Consider the SMA interface compatibility with existing infrastructure. Evaluate insertion loss and stopband rejection against application needs using official performance curves.

Part Context

Mini-Circuits produces a wide range of RF and microwave components, including filters, amplifiers, and mixers. The SLP-5+ belongs to their line of low-pass filters, which are essential for removing unwanted high-frequency noise. These components are widely used in telecommunications, aerospace, and industrial applications requiring precise signal filtering.

Replacement Considerations

Consult Mini-Circuits documentation for direct substitutes. Verify that any alternative maintains the 50 Ohm impedance and SMA connector type. Ensure the replacement meets the DC to 5 MHz operational range and similar electrical performance characteristics.

FAQ

What is the cutoff frequency of the SLP-5+?

The SLP-5+ has a specified cutoff frequency of 6 MHz.

What type of connectors does the SLP-5+ use?

The SLP-5+ uses SMA connectors for its in-line module interface.