FMCA100195-24

Overview

The FMCA100195-24 is a semi-rigid RF cable assembly manufactured by Fairview Microwave. It features 1.85mm female connectors on both ends, with one connector designed for bulkhead mounting. The assembly utilizes RG405 Type .086 semi-rigid coaxial cable and has a total length of 24 inches. The typical insertion loss for this configuration is 0.84 dB.

Feature Summary

• Utilizes RG405 Type .086 semi-rigid coaxial construction for high-performance stability
• Features 1.85mm female connectors at both termini
• Includes a bulkhead-mounting interface option

Applications

• High-performance RF signal transmission
• Semi-rigid interconnect applications requiring precise geometry

Procurement Notes

Verify the specific connector gender and mounting style against project requirements. Confirm that the 1.85mm interface compatibility matches existing equipment ports. Ensure the 24-inch length accommodates the physical routing constraints within the assembly. Check for any specific environmental ratings if the deployment involves extreme conditions.

Selection Notes

Select this component when rigid structural integrity and consistent electrical performance are prioritized over flexibility. The 1.85mm interface supports higher frequency operations compared to standard SMA or N-type variants. Consider the bulkhead mounting feature if panel isolation is required. Verify that the semi-rigid nature allows for the intended installation environment without inducing mechanical stress.

Part Context

This part belongs to Fairview Microwave's semi-rigid RF cable assembly line. These assemblies are engineered for applications demanding superior shielding and phase stability. The use of RG405 coax provides a robust dielectric structure suitable for demanding RF environments where standard flexible cables might degrade in performance.

Replacement Considerations

Direct substitutes must match the 1.85mm female-to-female configuration and RG405 .086 cable type. Length variations will alter insertion loss values. Alternative manufacturers may offer similar semi-rigid assemblies but require verification of dimensional tolerances and impedance consistency.