350-10-112-00-006000

Headers, Male Pins Overview

The Mill-Max 350-10-112-00-006000 is a through-hole interconnect header featuring 12 positions with a 0.100-inch (2.54mm) pin spacing. It utilizes unshrouded design and solder tail termination for board mounting. The connector employs gold-plated contacts to ensure reliable signal transmission in electronic assemblies.

Headers, Male Pins Feature Summary

• Through-hole solder tail termination for secure PCB mounting
• Unshrouded header design with 0.100 inch pitch
• Gold contact plating for enhanced conductivity

Headers, Male Pins Applications

• General purpose electronic circuit interconnections
• Board-to-board connection systems
• Prototype development and testing setups

Headers, Male Pins Procurement Notes

Verify the specific series designation and contact configuration against official Mill-Max datasheets before integration. Confirm that the unshrouded style aligns with system safety requirements. Ensure compatibility with mating connectors regarding pin count and pitch dimensions to prevent mechanical interference or electrical mismatch during assembly.

Headers, Male Pins Selection Notes

Select this component when a standard 12-position through-hole header is required. The 2.54mm spacing suits general electronics applications. Consider the unshrouded form factor for space-constrained designs where mating guides are unnecessary. Verify RoHS compliance status if environmental regulations apply to the final product assembly.

Headers, Male Pins Part Context

This part belongs to the Mill-Max 350 series of headers and wire housings. It serves as a fundamental interconnect solution within the manufacturer's precision-machined component portfolio. The series provides standardized options for various pin counts and termination styles, supporting diverse industrial and commercial electronic hardware needs.

Headers, Male Pins Replacement Considerations

Direct substitutes include other 12-position, 2.54mm pitch through-hole headers from compatible manufacturers. Verify mechanical footprint and contact material specifications match the original design requirements before swapping components.