RF Transmitters

RF Transmitters are used to send a radio frequency signal and modulate that signal to carry data from a system. The frequency range is from 315Hz to 64GHz with a data rate of 3kbps to 2Mbps and a power output from -30dBm to 24.7dBm. The data interface is connector, I2C, pads for pins, parallel, PCB, serial, solder pad, SPI, UART, and USB and an antenna connection of castellation, on-board, PCB, and through hole.

Screen Default Ranking Price By Date

Add ComparisonUp to 4 can be added

Start comparison Clear All

Recommended Products

ATA5749C-6DQY-64View Product

FM-RTFQ2-433PView Product

ALPHA-TX915SView Product

MAX2361EGMView Product

SI4710-B30-GMView Product

RCBTX-434View Product

Recent News

Four-lead bridge rectifier based on ChipApex category imagery beside an illustrative power supply

Oct 28, 2026

Bridge rectifier selection: ratings, ripple and heat

Select a bridge rectifier by reverse voltage, capacitor charging current, startup surge and cooling. Work through a stated DC voltage and ripple example.

Reed Relay Guide: Hot Switching, Leakage and Selection

Choose a reed relay for signal switching. Understand hot and cold switching, leakage, contact resistance, isolation and measurement settling requirements.

Common mode choke selection for power and signal lines

Select a common mode choke using noise frequency, current, insulation and signal integrity. Understand impedance curves, layout and filter limitations.